For SUZUKI GSF 1250 Bandit DL 650 VStrom GSXR 600 GSX-R 750 GSX-R750 SV 1000 SV650 SV1000 Motorcycle Gear Indicator Gear Display

Condition: 100% brand new

Color of light source: red, green, blue

Item name: speed gear indicator indicator

Size: approx. 4cm*4cm*4cm/1.57 inch*1.57 inch*1.57 inch

▲Package list:


1 x
Motorcycle gear indicator/bracket (as picture shown)

Shows current gear number

Shows current gear from 1 to maximum 6. Also a neutral indicator.

automatic programming

Compatible with all motorcycle, four wheeler, bicycle etc. will fit anything with gear lever

Detects current gear faster than other gear indicators that use a speedometer/tachometer signal.

The display can be mounted anywhere

Congratulations on your purchase of a gear position indicator. The most advanced gear position indicator on the market today. This product will fit Suzuki fuel injection (FI) motorcycles with onboard diagnostic system connector. This connector is for Suzuki manuals "mode selector switch coupler" It is called. Unlike other gear indicators available for your bike, this product connects to the diagnostic connector. It makes installation very simple. The unit reads data directly from the ECM, offering faster and more reliable readings than competitive products. The unit is fully automatic, no buttons and "programming cable" none, the display will show all gears correctly when the ignition is on, side stand up and engine stop switch in working position.

Locate the white, 6-pole male diagnostic connector, usually near the ECM box. A black cover or "doll" It may be connected to a female plug (radio). For GSF650 Bandit/GSF1250; Right side under chrome frame, for DL650 ABS model; Behind the fuel tank cap on the right side, for VL1500/Boulevard C90/Intruder C1500; Head cover behind left frame, other models; Remove the black cover or dummy female plug under the seat (Rider or saddle) and connect the plug. Route the cable to the mounting location. Remove the green plastic from the back of the unit and mount the display. Secure the cable with the cable ties provided. The unit is fully functional after installation. No need to install. Troubleshooting.

Disconnect the connector and check if the pins are broken, bent, or pushed out of position. Reconnect the plug, and make sure all connections are good and the connector is fully seated. Make sure the ignition is on, the side stand is up and the engine stop switch is in the working position when you test the gear position indicator. If some gears are not specified properly, most likely the gear Position switch is faulty, replaced or a box is installed. If the specified gears are correct except under hard acceleration or braking, the bike has interference and the ECM is receiving incorrect gear position readings from the sensor. This model adjusts the gear position by ECM.

1 x Motorcycle Speed ​​Gear indicator/bracket (as option shown in the picture)